Parts Accumulated

There are four lists below. First is a list of parts that have been used on the build. Second is a list of parts obtained for the build but not yet used. Third is a list of parts for sale. These were obtained, but not used. Fourth is a list of the parts that still need to be obtained. 

PARTS USED ON THE BUILD

  • 1961 Jeep Willys Tub, Fenders, Hood (Titled as a ’63. I’ll explain in person. There were no swaps, the Jeeps weren’t titled until sold.)
  • 1978? Jeepster Commando Frame
  • 4″ YJ Leaf Springs with Bushings (used)
  • Scout Front Dana 44 Axle (used)
  • Scout Rear Dana 44 Axle (used)

PARTS OBTAINED FOR THE BUILD

  • Remade VIN & Export Tag (Originals are still available)
  • Jeep has Colorado Title, free & clear
  • 1994 Chevy S10/Blazer 4.3L CPI Engine
  • Right Hand Drive Cherokee Power Steering Box (used)
  • 1994 K2500 NV4500 Transmission (used)
  • 0-9 Speedometer Cluster (new OEM) – extremely hard to find
  • Oil for NV4500 (new & added in transmission)
  • Shifter for NV4500 (new)
  • Jeep Dana 300 Transfer Case (used)
  • Twin Sticks for Dana 300 (new)
  • Centerforce Dual Friction Clutch (new)
  • Flywheel (new)
  • E2000 Fuel Pump (new)
  • Novak NV4500 to Dana 300 Adapter (Partially installed, I had to request that Novak finish the instructions. They did I have a pdf that I can send or print for the buyer.)
  • Slave Cylinder (new)
  • Advance Adapters NV4500 Bellhousing (new)
  • 1966-68? Mustang Radiator (used)
  • Novak Engine Mounts (new)
  • 36″ Super Swamper Tires (for build only, not good to drive) (used)
  • Black Rims (holding tires)
  • 1″ Body Lift (new)
  • Rear Corner Guards, Black, Smooth, Uncut (new)
  • Rock Rails (new)
  • TJ Fender Flares (used)
  • DJ-5 Steering Column (used)
  • DJ-5 Steering Box Mount (used)
  • Cherokee Pedal Assembly (used)
  • Cherokee Master Brake Cylinder (used)
  • CJ-6 Blinkers (used)
  • Early CJ-5 Windshield (used)
  • ’90s Chevy Transmission Skid Plate
  • Firestick Antenna (used but great condition)
  • CB (used)
  • Maglite Mount for early CJ-5 Steering Column (used)
  • CJ-7 Sun Visors (used)
  • Antenna Mount (used)
  • Bikini Top for CJ-5 (used)
  • Rear Bench Seat for CJ-5 (used)
  • Under Hood Toolbox (if possible – for a late model CJ) 
  • Nut Replacement for Engine
  • Tailgates (2 or 3 used “Willy’s” tailgates)
  • Floor Pans (new) – from Classic Enterprises
  • Grill (used – CJ-7)
  • Grill (original, red)
  • Spare Hood (correct era with the snorkle hole)

ADDITIONAL PARTS THAT WILL BE INCLUDED

  • Late CJ Gas Tank
  • 1976 Jeep Factory Service Manual
  • Original CJ-6 Steering Column
  • Original CJ-6 Pedals 
  • Original Transmission & Transer Case (the transmission confirms this was a pre-1962 jeep)
  • Wheel Dollies
  • Cherry Picker/Engine Hoist

PARTS THAT ARE STILL NEEDED

  • New Soft Top
  • Seats
  • Seatbelts
  • Gauges
  • Electric Fan
  • Steering Wheel
  • Windshield Wipers
  • Fuel Lines
  • Brake Lines
  • Gas Tank
  • Side Mirrors
  • Rear View Mirror
  • Windshield
  • Wiring Harness
  • New Windshield & Hood Hardware
  • Headlights
  • Tail Lights
  • Lift Leaf Springs
  • Stereo
  • Speakers
  • Swing Away Tire Carrier / Rear Bumper
  • Front Bumper with Stinger?
  • Better Axles with Lockers
  • 37″ BF Goodrich KM2 Tires
  • Roll Cage

[supsystic-gallery id=4]

Leave A Comment

Name

Website

Comment